- Open Control Panel -> System and Security -> Windows Firewall -> Advanced Settings
- Open "Inbound rules" on the left pane, click "New rule" on the right pane
- In a new rule, you can specify the required port, protocol, profile the rule is applied to and assign the rule name. Please see this document for ports and protocols used by Connect.
- You'll need root privileges to add changes to your iptables. Please use the following command to add rules to iptables:
iptables -I INPUT -p tcp --dport <destinantion_port> -j ACCEPTThis command will add a new rule to the top of your INPUT chain to allow incoming TCP packets to the specified port. You can check here which ports are used by Connect.
- If you want to make your iptables permanent so as not to get them reset every reboot, use the
iptables-save > <your_filename>command to save the current iptables status to a file, then load iptables on boot using the
You can place the command for loading rules to the /etc/rc.local file or any other script which executes upon boot.